Help
Made 143.5bhp before it was fitted so should be about 150bhp now as it is a screamer!
Car will hopefully be going on rollers this week and will upload the two before and after rolling roads to get a direct comparison.
Page 1 of 1
New Lms 180 Inlet Fitted
#1
Posted 01 September 2014 - 01:34 PM
Here a new LMS 180 inlet fitted to silverbullit99 on Saturday.
Made 143.5bhp before it was fitted so should be about 150bhp now as it is a screamer!
Car will hopefully be going on rollers this week and will upload the two before and after rolling roads to get a direct comparison.
Made 143.5bhp before it was fitted so should be about 150bhp now as it is a screamer!
Car will hopefully be going on rollers this week and will upload the two before and after rolling roads to get a direct comparison.
#2
Posted 07 September 2014 - 08:15 PM
Very spangly 
Will it be the same rolling road for the before and after?
Will it be the same rolling road for the before and after?
searching is fruitful | I'm a sponge not a mechanic | please do try that if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own sometimes still seen for sale
#3
Posted 08 September 2014 - 06:41 PM
Yes same RR before and after to get most accurate results.
Bit of luck it could be going on tomorrow or asap.
Cheers
Ally
Bit of luck it could be going on tomorrow or asap.
Cheers
Ally
#4
Posted 12 September 2014 - 06:37 PM
Car made 152.5bhp peak at 7200rpm after inlet was fitted 129 lbft of torque
Car before was 143.5 bhp and 132 lbft.
The rolling road graph shows before and after
GREEN before
RED after inlet fitted.
This post has been edited by ally frp364: 12 September 2014 - 06:37 PM
#5
- Group: Moderators
- Posts: 2133
- Joined: 11-February 03
- Location:On a racetrack somewhere
Posted 15 September 2014 - 12:14 PM
based on the graph shown it looks like its lost mid range torque and power between 4k and 6k 
, all gain above 6400 though
Might benefit change of cams now to make power power at higher rpms
, all gain above 6400 though Might benefit change of cams now to make power power at higher rpms
A little knowledge is a dangerous thing (Alexander Pope - 1709)
Stop being spoon fed and GOOGLE it!
Stop being spoon fed and GOOGLE it!
Share this topic:
Page 1 of 1