Vice ..a must!
Jack and Axle Stands[b/]
Brake Bleeding Kit
Compressor (at least 2hp) 2.5 or 3 even better... + Hose (at least 8mm)
Air Ratchet(optional)...
17mm spanner and socket for removal of caliper....
13mm spanner x 2 for undoing the Brake hoses
11mm spanner for Bleed Screws
Brake Piston Spreader (only use if pistons are clean...but also handy in other situations..)
Brake Cleaner from local motor factors... or ebay... (Wynns is a particually good one!...)
[b]High Temp RTV sealant - for the back of pads...
Garnet Paper 100 grit (as recommended by stoptec) for pad re-finishing/surfacing.... (Don't use aluminium oxide paper)
Here are the Parts for a full overhaul (presuming Pad retainer rails will be re-used)
Chris
FRP453
This post has been edited by eldoodarino: 13 July 2010 - 10:49 AM