Help
hi i have just put a leather interior in my puma and i now have an airbag light flashing on the dash, can this be reset by disconnecting the battery for a couple of hours?
Page 1 of 1
Puma Interior
Rate Topic:
#1
- Group: Members
- Posts: 19
- Joined: 19-November 15
- Location:Tunbridge Wells Kent
Posted 07 February 2016 - 05:13 PM
#2
Posted 07 February 2016 - 05:37 PM
Did you not disconnect the battery before you started when you put the front seats in?
searching is fruitful | I'm a sponge not a mechanic | please do try that if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own sometimes still seen for sale
#3
- Group: Members
- Posts: 19
- Joined: 19-November 15
- Location:Tunbridge Wells Kent
Posted 12 February 2016 - 03:39 AM
I did not silly me
happy-kat, on 07 February 2016 - 05:37 PM, said:
Did you not disconnect the battery before you started when you put the front seats in?
#4
Posted 12 February 2016 - 09:24 AM
I would say lucky you as the airbags could have fired.
Disconnect battery wait at least 30 minutes, I would wait much longer. Then check the connections again that are under the seats you might have clipped one back badly.
Reconnect battery and hope all is OK and do the radio code.
If you still have problems maybe one of the new seats has a broken/bad connector on it.
Disconnect battery wait at least 30 minutes, I would wait much longer. Then check the connections again that are under the seats you might have clipped one back badly.
Reconnect battery and hope all is OK and do the radio code.
If you still have problems maybe one of the new seats has a broken/bad connector on it.
searching is fruitful | I'm a sponge not a mechanic | please do try that if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own sometimes still seen for sale
Share this topic:
Page 1 of 1