1.4 To 1.7 Swap se abowe :)
#1
Posted 20 September 2011 - 06:35 PM
I may be getting a new puma in a few weeks, (still undecided) it's a 99 00 1.4, it's suposedly mint, so it's a better starting point for my frp convercion so I'm thinking, kick the 1.4 to the curb, and slipp my 1.7 inn, after it's gotten a nice workover
but again, is the wiering the same?? ie. the vct??
thnx for any ansvers
if all else fails, I do have a complet working donor car, so swapping everithing is not an issue, just a hassle
Projekt tread http://www.pumapeopl...pic=104790&st=0
Time, is the fire in which we burn
#2
Posted 21 September 2011 - 04:16 PM
#3
Posted 21 September 2011 - 06:59 PM
Projekt tread http://www.pumapeopl...pic=104790&st=0
Time, is the fire in which we burn
#4
Posted 23 October 2011 - 07:14 PM
i'm doing the same at this moment just removed the damaged 1.4 engine,
after cleaner the engine bay I'm going to remover the 1.7 engine out of the donor Puma
replace when it;s out the cambelt, waterpump and clutch before placing it again
it can be done
cheers
gijs
#5
Posted 23 October 2011 - 08:37 PM
pleace let us know how your getting on, as there is little to no info on this to be found
Projekt tread http://www.pumapeopl...pic=104790&st=0
Time, is the fire in which we burn
#6
Posted 23 October 2011 - 08:57 PM
yes you need to swap the loom and ecu , but not all of it only the engine part , so you also need to remove your dash
CartMan, on 23 October 2011 - 08:37 PM, said:
pleace let us know how your getting on, as there is little to no info on this to be found
#7
Posted 23 October 2011 - 09:03 PM
anyway, the car I was going to get and do this to, has not arived yet, so.... we'l se
Projekt tread http://www.pumapeopl...pic=104790&st=0
Time, is the fire in which we burn
#9
Posted 13 November 2011 - 10:44 PM
#10
Posted 14 November 2011 - 12:05 PM
All stuff puma - puma technical & all things rebuilt...
See my website for Snow School Information
#11
Posted 14 November 2011 - 01:02 PM
now stripping my old car , remove the engine and change cambelt, clutch before fitting it into my new Puma
volcomstone411, on 14 November 2011 - 12:05 PM, said:
#12
Posted 14 November 2011 - 04:34 PM
All stuff puma - puma technical & all things rebuilt...
See my website for Snow School Information
#14
Posted 24 November 2017 - 09:09 PM
#15
Posted 24 November 2017 - 10:11 PM
Left side engine mount
Air box lid
MAF mass air flow sensor
Air intake pipe