Help
Have been looking at getting 16" alloys for the puma but it looks like (even though ebay and alloy websites say they fit) they are et40. Puma has et 34.
for eaxmple:
Brand New 7x16" Dare Madisson Gunmetal Polished Special Offer Alloy Wheels. Fitments available 4x100 et40, 4x108 et40. - http://www.alloywhee...loy_Wheels_Only
http://www.ebay.co.u...=item589cedcf26
No doubt a few people on here have 16's on their puma so was looking for advice on what rim width (6, 6.5j or 7j) and offset I should be looking for. Stud diameter should be 108 i am guessing.
Any help would be much appreciated.
Cheers
Bry
Page 1 of 1
16" Alloys On The Puma
#2
Posted 18 April 2013 - 07:12 AM
You will have to look at the following...
- The fitment is: 4x108 (4 studs, diameter 108mm)
- ET offset should be between ET30 and ET38... (doubt if you want to go further because you don't want to drive it like shit... which i quite find it driving along with ET40 scorpio wheels)
width can be 7j without a problem
- The fitment is: 4x108 (4 studs, diameter 108mm)
- ET offset should be between ET30 and ET38... (doubt if you want to go further because you don't want to drive it like shit... which i quite find it driving along with ET40 scorpio wheels)
width can be 7j without a problem
#3
Posted 18 April 2013 - 06:27 PM
cheers for your reply, basically then looking for something like these
http://www.ebay.co.u...=item4843f91dcd
http://www.ebay.co.u...=item4843f91dcd
#4
Posted 18 April 2013 - 07:58 PM
you just want to make sure the middle hole (dont know the english word for that!) is 63,4mm wide!
Share this topic:
Page 1 of 1