All carpet and headlining is out, as are the back seats and rear cars / trim panels.
I've then bought a set of side mount Motordrive pro bucket seats, and am looking at fitting them, but it's not so straightforward due to the ridges in the floor pan where the front seats bolt down.
A few people have suggested you can buy Fiesta Mk3.5 rails and then bolt side mount brackets and the seatbelt clip onto these so you get the benefit of a slider and subframe without having to pay £120+ each side for the OMP subframe and slider.
Is this correct, and if so, anyone know a good breaker who does them for reasonable prices - I've seen a few on eBay but I'm not paying £100 for a pair of rails from a flaming Fiesta!
Alternatives? I don't really want to have to weld more into the car and similarly don't want to have to have anything fabricated if I can avoid it as I don't have the kit for either.
Cheers
This post has been edited by 400AndRising: 03 August 2017 - 11:10 AM