Pumapeople: Cam Tool Question - Pumapeople

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Cam Tool Question

#1 User is offline   rsindigo 

  • Group: Members
  • Posts: 141
  • Joined: 01-June 08
  • Location:Leicester

Posted 23 May 2017 - 04:10 PM


I took my FRP to my local garage today to have the cam belt changed, I provided the cam tool 303-692 (21-246) which I had previously purchased from ebay.

The garage said they could NOT use the cam tool I provided because the pin on my cam tool was too large?

I have just measured the pin diameter on my cam tool at 8.94mm.

Just wondering if anyone on here who has ownership of the correct cam tool could confirm the diameter of their cam tool pin for me please.

I don't understand why my cam tool could not be used?

#2 User is offline   stoke7up 

  • Group: Members
  • Posts: 93
  • Joined: 24-March 04
  • Location:stoke on trent

Posted 25 May 2017 - 03:26 PM

I'm sure I recall a thread on the other puma forum, with a drawing of the tool and its pin is 9mm.


#3 User is offline   happy-kat 

  • Group: Admin
  • Posts: 21786
  • Joined: 10-February 03
  • Location:Sarnian abroad

Posted 25 May 2017 - 09:39 PM

Hopefully someone can reply to help.
searching is fruitful | I'm a sponge not a mechanic | The Wiki is cool, please do check there if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own link coming soon

Share this topic:

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic