hi, can anyone tell me where the crankshaft sensor is located, from reading a few posts i am hoping this is the problem with my puma.
Page 1 of 1
Whereabouts Is The Crankshaft Sensor Located?
#2
Posted 27 May 2008 - 07:34 PM
I can't comment on if it is safe to remove or fiddle with, or even if the battery needs to be disconnected first etc. but I think it is located in the red circle, but this is not from accurate knowledge, I think that pipe is the dip stick
(my oil leak has been fixed)
(my oil leak has been fixed)
searching is fruitful | I'm a sponge not a mechanic | please do try that if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own sometimes still seen for sale
#4
Posted 27 May 2008 - 09:52 PM
save as houses, just take of the connector and remove the 8mm bolt i think it is the pull like a bugger
#5
Posted 05 March 2012 - 10:50 AM
Hello,
Newbie here.
I urgently need a picture or guide showing where the crankshaft sensor is located.
I need to pull it within an hour or so.
Please help.
Newbie here.
I urgently need a picture or guide showing where the crankshaft sensor is located.
I need to pull it within an hour or so.
Please help.
#6
Posted 08 March 2012 - 09:50 PM
goes on the end of the gearbox very low down on the front. It's below the starter motor. It measures indentations on the flywheel. When there is 3 indentations joined together it's 100 degress before the engine reaches top dead centre.
All stuff puma - puma technical & all things rebuilt...
See my website for Snow School Information
Share this topic:
Page 1 of 1