Pumapeople: Digital Guide Fitting - Pumapeople

Jump to content

  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic

Digital Guide Fitting This on my RS2000 but will work for Puma's

#21 User is offline   martytay 

  • Group: Members
  • Posts: 15
  • Joined: 26-March 15
  • Location:France

Posted 02 April 2015 - 05:01 PM

I'm retrofitting a digidash into my early Puma, I can confirm the water temp gauge works perfect when connecting the multiplug PIN25 to the original analogue sender (PIN 7 on original white analogue plug)

You do have to remove PIN 19 (not needed) and fit it in the hole for PIN 25 (as its missing on the Puma plug)

When ticking over its showing 62°C on the LCD

I have tested all the other lights etc and thy all work except the fuel gauge and low washer light, hopefully these will work once connected . I did try and test the low washer light but it won't go off, I would have thought the low washer light would have gone off when grounded? but it doesn't so I'm guessing the auxiliary warning module must control it somehow?



Share this topic:


  • 2 Pages +
  • 1
  • 2
  • You cannot start a new topic
  • You cannot reply to this topic