Pumapeople: Exhaust Donut - Pumapeople

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Exhaust Donut

#1 User is offline   RichardP 

  • Group: Members
  • Posts: 11
  • Joined: 17-November 15

Posted 06 February 2017 - 07:16 AM

I've almost finished the engine rebuild on FRP no 219 (pic/thread coming soon) but I need to replace the donut and spring bolts that connect the manifold to the cat. Can anyone tell me where I can get a set?
Thanks :)

#2 User is offline   happy-kat 

  • Group: Admin
  • Posts: 21772
  • Joined: 10-February 03
  • Location:Sarnian abroad

Posted 06 February 2017 - 09:02 AM

Hopefully Chris will respond.
What exhaust system have you used?
searching is fruitful | I'm a sponge not a mechanic | The Wiki is cool, please do check there if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own link coming soon

#3 User is offline   RichardP 

  • Group: Members
  • Posts: 11
  • Joined: 17-November 15

Posted 06 February 2017 - 09:23 AM

I'm pretty sure everything is standard, the manifold certainly has all the correct heat shield fixings etc.

#4 User is offline   happy-kat 

  • Group: Admin
  • Posts: 21772
  • Joined: 10-February 03
  • Location:Sarnian abroad

Posted 06 February 2017 - 03:07 PM

I'm surprised the original mild steel is still ok (unless has been garage stored).
searching is fruitful | I'm a sponge not a mechanic | The Wiki is cool, please do check there if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own link coming soon

#5 User is offline   RichardP 

  • Group: Members
  • Posts: 11
  • Joined: 17-November 15

Posted 06 February 2017 - 07:27 PM

I've done some research today and been under the car to measure it. The manifold has two Lambda ports which as I understand makes it a MIllTek system??
The ID of the donut would need to be 57mm which I can find on eBay so I might get one from there and make some sprung bolts at work. Failing that I did speak to Pumabuild today and the guy I spoke to said he might have some knocking about.

Like a lot of parts for this car, it's been a lot harder work than I thought it would be Posted Image

#6 User is offline   happy-kat 

  • Group: Admin
  • Posts: 21772
  • Joined: 10-February 03
  • Location:Sarnian abroad

Posted 06 February 2017 - 08:19 PM

Not as far as I recall the Miltek like others only had one sensor, because if fitted to a standard it presented warning light on the dash on late Pumas.
Pass sorry I had a quick search but couldn't find details about it having two.
searching is fruitful | I'm a sponge not a mechanic | The Wiki is cool, please do check there if stuck with a Puma problem whilst waiting for a reply | For the Puma fan this read 'The Inside Story Book' is very nice to own link coming soon

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic