Hi Guys
I'm replacing the cylinder head on a 1.7 Puma after a belt snap and need the torque settings of head bolts, cam sprocket, cam carrier, belt tensioner and crank pulley bolts etc.
Had a little look but can't find them on here. Can anyone list them for me or link me to a page that has them?
Also any hints on doing the timing from scratch (line up no.1 on TDC and use the cam locking kit?) and the inlet cam would be appreciated.
Many thanks........
Page 1 of 1
Bolt Torques torque of bolts
#2
Posted 23 April 2010 - 02:37 PM
check out the wiki,there is a complete section on how to change the cam belt on a 1.7....
#3
Posted 23 April 2010 - 07:41 PM
Head Bolts. 15 Nm then 30Nm then +90 degrees
Camshaft Pulleys. Inlet 105 Nm. Exhaust 60 Nm
Cam Carrier Caps. 8 Nm then 17 Nm
Cambelt Tensioner. 20 Nm
Crankshaft Pulley. 40 Nm then +90 degrees.
Camshaft Pulleys. Inlet 105 Nm. Exhaust 60 Nm
Cam Carrier Caps. 8 Nm then 17 Nm
Cambelt Tensioner. 20 Nm
Crankshaft Pulley. 40 Nm then +90 degrees.
Share this topic:
Page 1 of 1