My Girlfriend spotted K7 BTR Yesterday (22/12/11) on the army and navy flyover in Chelmsford.
Anyone on here?
Page 1 of 1
K7 Btr - Chelmsford - 22/12/11
#3
Posted 24 December 2011 - 09:51 AM
I have FRP 190, plate is L90 FRP. Where abouts are you from? And I assume you have number 62 from your username .
She said sorry she went so slow coming off the flyover she was too busy staring at the puma as you came up behind her! .
She said sorry she went so slow coming off the flyover she was too busy staring at the puma as you came up behind her! .
#4
Posted 25 December 2011 - 01:31 AM
Bentleya, on 24 December 2011 - 09:51 AM, said:
I have FRP 190, plate is L90 FRP. Where abouts are you from? And I assume you have number 62 from your username .
She said sorry she went so slow coming off the flyover she was too busy staring at the puma as you came up behind her! .
She said sorry she went so slow coming off the flyover she was too busy staring at the puma as you came up behind her! .
I take it you have tuned yours then 190?
I am in Eastwood, Leigh on Sea, where are you located?
I take it that was the New SEAT Ibiza if my memory is correct?
#5
Posted 03 June 2012 - 07:39 PM
Aaron I have a technical question.
When you open the Fuel flap I have noticed a small hole which is cut into the plasic where near where you remove the cap with the key to refuel. I take it this is to allow for the water that builds up behind the flap to flow away.
My question is where does the water go is it straight into the inner wing or does it have a drain pipe to carry it away.
Reason I ask is if it is meant to go into the inner wing then I want to ensure I have enough protection in there to ensure that the car will not rust.
Cheers
Ian
When you open the Fuel flap I have noticed a small hole which is cut into the plasic where near where you remove the cap with the key to refuel. I take it this is to allow for the water that builds up behind the flap to flow away.
My question is where does the water go is it straight into the inner wing or does it have a drain pipe to carry it away.
Reason I ask is if it is meant to go into the inner wing then I want to ensure I have enough protection in there to ensure that the car will not rust.
Cheers
Ian
Share this topic:
Page 1 of 1